ha.. yes we need a curley video.....

The materials performance is related to the washing.... Wash often. Bacon grease from breakfast, sunscreen from morning, cheese from lunch, and sweaty palms from evening climb all make the DWR wear out.

Wash cold to warm water, use a nikwax tech wash, or a mild soap. avoid normal laundry detergent, it has surfactants (the opposite of DWR).

After a summer of washes and wears, for best performance, spray on a DWR. Nikwax softshell, or a TX direct. dry a bit on medium heat and it will evenly coat the outside, and make a Big improvement in maintaining DWR.

The key to a softshell working as a shell, is a strong water repellancy on the surface.

UPF 50 ratings on the shirts that are color, and a UPF 30 on the White.

Very light, but very tightly knitted.

Fitted would be a large, but you need to check arm length, and compare to size chart.

An XL would be good for layering under, and having plenty of arm length.

Stuff the coat into the kangaroo pocket, and the kangaroo pocket with turn inside out, with the entire jacket on the inside. the inside material of the kangaroo pocket is now showing, but its the sample body fabric. the best pillow....

the 150 is also made of very fine 17.5 micron merino wool - very soft and comfortable, and lightweight. the 200 gram per square meter uses 18.9 merino wool, more insulation and more durable wool.

A patch of material is good, and then use a seam grip, or aquaseal, or a Polyurethane glue. apply the glue to the patch and apply to the hole. then add a piece of wax paper and lay a large book or dictionary on top to keep it flat. wait over night and you have a patch that is well bonded and waterproof. The goretex patches, and other patches with a self adhesive on one side i have tried to do not stay on.

burnt orange jacket with the redrock zippers are live....

same shell material, and same laminate, but the two layer does not need the internal bonded layer, and so makes the material feel lighter

you can wash them, but i would not advise washing them a bunch of times.

the poly fill will hold up. hang dry

depending on the Ape factor, i would lean to XL. check the more detailed fit dimensions on the size chart, height is not enough data to say for sure. See Size? just under the select options bar....

bombshell bib is heavier face fabric for more durability. the three layer materials are heavier because of the internal layer. the bombshell insulated is only two layer - outside shell and membrane.

this jacket is warmer and more breathable. if you are looking for the powershield performance - which is a laminate and perhaps a little less bulk, check out the stoic welder lo.

great idea! to keep weight and bulk down on bombshells we do not add the extra zipper, but is a great feature for future!

medium should do well.. collar to inseam measure is about 33 inches on garment

height and weight is not quite enough to judge size... try using the size tab, just under the 'select options' this give you better specific dimensions for waist, and inseam. these measures will result in an athletic fit, if you want loose, go up a size.

it is not 100% windproof, as it has some air permeability features. about 95% windproof, with the remaining allowing some air exchange about 6-10 cfm. this allows the jacket to breathe when exerting in the mountains - hiking for side country gates, touring up alpine, or climbing. the TNF apex summit uses WINDBLOC - windproof, but poor breathability - means you can get wet with exertion

this is fitted, and will work well to keep you warm with a merino layer, or synthetic layer.

will work great, but you may want go up a size. the cuffs keep the arm openings where you need it, and easier to get on over other layers.

there is no bulk with this Hadron. the whole thing will stuff into a sandwich bag!
the hood will fill the space that is left, without pressure.

unlike wearing a fleece, or cotton hoodie.

if you like the older goat merino styles from 2009, you will love the 200 weight from stoic. the 200 grams per square meter is heavier, more dense and uses 18.9 micron merino, which results in warmer and a more structured material. this 150 gsm is light, and uses a soft 17.5 merino, personally my favorite for its great feel, and just enough warmth.

your bombshell will not leak. the welded seams are more reliable than sewn, and seamtaped. this colorway is tonal but uses the same patterns as those with a highlight seam.

the sic0126 uses a different quilting pattern for 2011, and some color changes - otherwise same size and materials.

check the sizing chart. height and weight is not as important as waist size, and inseam size. find size chart just under 'select options'.

all the stoic logo are a silver reflective, very bright reflective too.

the tour pant is good thick material. i used in March on haute route, and used every day, and they were great - but that is a lot of touring, skinning, and climbing, and then some skiing. if inbounds skiing on cold days, a layer inside is good, or a ski pant over is good.

i think the detail image of the color and stoic logo is the most accurate. a bit darker than the front shot of GRAZE. other stoic styles use this graze also.

XL anorak is .95 lbs. this is a heavier layer, that is great on its own, or as a great layering piece in cold weather.

the welder lo softshell has a fleece lining so it is warm, but the powershield material does allow air to permeate (93% windproof). if you are skiing inbounds, then you generate less heat than hiking or touring, and may need a layer under, or a layer over.

this glove will keep you warm and has great dexterity,and with good circulation, and good level of activity can keep you warm. but it is not the warmest glove or mitten out there. for extreme cold, sedentary conditions like sitting on slow chair lift, the welder trigger mitt gives good dexterity while still being very warm, or mittens are a the best go to.

height and weight is not enough.... check your body dimensions against the chart for size and fit... just below the 'select options' in the gray box. this helps you define what a standard fit is. if you want looser for fashion, or you plan growing, go up a size.

you can use indoors, but keep ventilation as CO is an output of the propane being burned

the SE pant, special edition, is the schoeller version of the tour pant. same pant and cut, just using the schoeller materials... great you guys like the goat!

see stoic overhang short

the water resistance is good for light and fast conditions - the jacket is light, and when it starts raining its time to run to the car fast! the material does not use a coating, so the breathability is great. the DWR finish we use will repel water, but intended only for the short interval during aerobic activities that keep you warm. If in constant wet weather, a vaporshell jacket would be more suitable.

This material has great breathability, and even a small amount of air permeability approx 4-7 cfm. because this lightweight fabric does not have any coatings, it will breath better than most lightweight shells. we rely on the tight weave and DWR for it weather proofness, but still maintains the ability to breathe and self regulate for comfort.

because material prices have increased, and labor wages have increased. and the US dollar has decreased

The CFM rating is approx 4-7 cfm of air permeability. being a waterproof jacket, this unique quality allows a small amount of air to pass through the membrane, and more importantly, allows the moisture rich air inside the jacket to pass out of the jacket. a Gore-tex jacket has 0 cfm rating, but also performs much less in breathability.

2 oz of down, 850 fill power = very low weight, very packable, and great insulation

there is the purple, the green graze, and a gray excalibur if you want garish we have garish, if you want to blend in with the locals you can do that too...

yes the vintage is the same color in the other hadron styles - much better than the green in my opinion

very different shorts! lighter weight material, welded construction, only the two front pockets, and cinch instead of belt buckles. different cut as well.

we would like to see this delamination... please contact customer service, and they will provide you with a new one, and we would like you send this one back.

thanks for your testing....

183 grams for a XL, or 6 .4 oz.

damn light...

similar to the shift...

improved upon the shift by being welded instead of sewn, and monolith softshell is more durable than the powershield.

the microlith pant is lighter than the overhang. about 20% lighter due to lighter material, and no front or rear pockets. welded thigh pocket, and a built in web belt.

there is one in stock, but that is it for the season

this is it for the season...

no more crews coming in! check out the merino bliss - same great material, but with a little collar, 1/4 zip, and a small pocket.

black black in medium is available in the merino bliss!

http://www.backcountry.com/stoic-merino-bliss-shirt-long-sleeve-mens

bliss has a small collar, 1/4 zip, and small pocket great for phone or ipod under all the layers.

no more black black in medium in for the season

north dakota is cold and windy, but we have colder temps and wind in the wasatch mountains. it is completely windproof.
it is not however not insulated. you may want to look at the stoic bombshell insulated for something warmer, it depends on what you are doing while wearing the jacket, how aerobic activity is, this makes a big difference.

check the sizing chart. this describes a body that it will fit, regardless if its a man or woman.

no more green twill for the season... got to act fast!

this is a fleece lining bonded to the nylon woven softshell material. NO static!

check back with us for a new and improved rime - called the Microlith pullover. it is still a pullover softshell, but now Welded!

more for less. the apex bionic material is a laminate with less breathability, and less weather resistance. this monolith with the welded seams is great at shedding weather. and at a better price!

They have a heavy merino liner in them, and a small amount of primaloft in the back of the hand. They are pretty warm, but pretty dextrous too, so that is always a tradeoff...
We backcountry ski in the wasatch, and air temps can be zero, and blowing, hands are still great. but sitting on a lift for a long time, or being pretty still, your hands get cold.

this year, the merino wool is thick, and makes the glove feel a little tight out of the bag. size up if you are concerned, and wear them a day to help pack in the liner.

Luft hoody insulated sweater has the hood... sorry no down sweaters with hoods

it is a three layer shell. This type of jacket cuts wind great, and keeps you dry, and allows body perspiration to escape (again the focus is to keep you dry inside). there is room for layering insulation under the jacket...
if you want an insulated one, check out the bombshell insulated, and welder insulated from STOIC

they are a large #10 waterproof zipper that is pretty smooth. they are a little stiff because of the waterproofness, but i would not say snaggy..

here are some sizes for you...

large is approx 15x15x28 inches

XL is 17x17x36 inches

the fit on the anorak is more correct to size, a little looser than the event shell so its easier to get on, but not as loose or long as the sweater. the asymm anorak image, the guy in TRON pose, is a medium.

just counted the links on the image.... 102 links, so about 51 inches.

the bag is made of a PU coated nylon material, and welded at the seams. this construction if waterproof, and the material will not soak up water. the zipper is a pu coated zipper, however the one spot that may let water in, is where the two zipper heads come together. i have used this duffel a lot for weekend camping trips and store in the back of my open pick up. i put the zipper side down when raining to keep contents dry.

44 inches talon... like the specs say in upper corner...

gray goose down, 800 fill power. goose is the only 800 fill. duck can only be about 700 fill power.

these tubes have 60mm presta valves...

these new merino shirts are made of a better merino wool. 17.5 micron which is softer. quality is great. durability may not be better, but the softness and feel of the merino is better. for more durability and off width climbing, try the Breathe tech tee, a more durable polyester yarn.

yes there are some new larger pots in we are looking at, as you have suggested the 1000 ML is a great size... thanks for suggestion

these are the same pant design, different material. the new material is a little heavier, but will breathe well and hold up to a summer full of trail time, climbing, or adventures.

they have a great DWR on them, so backcountry skiing is great. in bounds, they may breathe too well!
great for hiking, climbing, and backpacking, and adventure travel...

hey big bird,

i am sure there is no hate out there. sorry bike is not offered in larger size at this time, but will try to get for future orders.

new colors coming in F10